view article
Figure 10
CAD-renderings and images of the mixer and assembly process with approximate time estimates for each major step. (a) Assembly commenced with the attachment of a polyamide capillary (500 µm inner diameter, 554 µm outer diameter) to the chip with a ∼0.5 µl drop of 5 minute ep­oxy. (b) After the ep­oxy dried, the chip-capillary subassembly was mounted on the holder including inlet O-rings seals. The chip and O-rings were secured in the holder with a custom acrylic clamp. (c) Next, the holder was secured to the black acrylic holder plate. Shown here are three CAD renderings of the holder plate and associated holder offset and outlet tee components. The top right of (c) shows an image of the assembled device. The bottom right corner of (c) shows the mixer assembly at the X-ray beamline.

Journal logoJOURNAL OF
SYNCHROTRON
RADIATION
ISSN: 1600-5775
Volume 28| Part 4| July 2021| Pages 1100-1113
https://doi.org/10.1107/S1600577521003830
Follow J. Synchrotron Rad.
Sign up for e-alerts
E-alerts
Follow J. Synchrotron Rad. on Twitter
Twitter
Follow us on facebook
Facebook
Sign up for RSS feeds
RSS