addenda and errata
Millisecond timescale reactions observed via
in a 3D microfabricated fused silica mixer. CorrigendumaStanford University, Stanford, CA 94305, USA, bUniversity of Guadalajara, 44430 Guadalajara, Mexico, cStanford Synchrotron Radiation Lightsource, SLAC National Accelerator Laboratory, Stanford University, Menlo Park, CA 94025, USA, and dLinac Coherent Light Source, SLAC National Accelerator Laboratory, Stanford University, Menlo Park, CA 94025, USA
*Correspondence e-mail: tkroll@slac.stanford.edu, juan.santiago@stanford.edu
A figure in the article by Huyke et al. [(2021), J. Synchrotron Rad. 28, 1100–1113] is corrected.
Keywords: microfluidics; mixing; X-ray spectroscopy; kinetics; 3D microfabrication.
The length of the chip was labeled incorrectly in Fig. 9 of the original publication. Specifically, the 12.8 mm dimension applies for the entire length of the chip. For convenience, we also show here the locations of the three inlet ports (these were shown correctly in the original CAD-file of the supporting information). Note that this correction does not influence the discussions or conclusions. The correct figure is shown below.
References
Huyke, D. A., Ramachandran, A., Ramirez-Neri, O., Guerrero-Cruz, J. A., Gee, L. B., Braun, A., Sokaras, D., Garcia-Estrada, B., Solomon, E. I., Hedman, B., Delgado-Jaime, M. U., DePonte, D. P., Kroll, T. & Santiago, J. G. (2021). J. Synchrotron Rad. 28, 1100–1113. Web of Science CrossRef CAS IUCr Journals Google Scholar
This is an open-access article distributed under the terms of the Creative Commons Attribution (CC-BY) Licence, which permits unrestricted use, distribution, and reproduction in any medium, provided the original authors and source are cited.